ESAM 3400 display does not work properly
Posted by: Nick_Lumpi June 14, 2024 08:18 am
Hello dear coffee community,
The display on our Esam 3400 shows strange things after plugging in the plug.
However, when I load the test mode, it works normally.
The drama started with the words "grinder too fine, .... ). After I cleaned the grinder, installed a new brewing piston with flow heater and a new water pump, it ran for a day, then there was the big bang. The display then went dead.
I then replaced the power board, reed board and solenoid valve.
At least it now shows something on the display and I can start the test mode, but at some point it goes off by itself.
I hope one of you can help here, although of course it's proven to me that remote diagnoses are difficult.
VG Nick
Bean2cup.org > DeLonghi > ESAM 3400 display does not work properly