Hello
,I have the following problem. For some time I have been playing around with a Krups EA9078. I have already replaced some things, after I had changed all the seals, I had to end now completely change the brewing unit. Already after the seal replacement of the brewing unit, I noticed that I could no longer perform a calibration (previously was it always Wrong - the menu has displayed incorrect values after the measurement).
I go to the service menu, go to "Activate and Calibrate" but the measurement always gives a thickness of zero.
Also when I select validate sensor, the plunger goes down and shows zero and when it arrives on the 13.5mm cake tool. At the top of the brewing unit is such a "cage" in which is a sensor that indicates how far down the piston is.
Also this sensor I have already ordered new and replaced, but I still do not get calibrated...
Does anyone have an idea what else this can be? Did I forget anything during installation?
I have also already changed the circuit board ...
I do not know any further....
close
Share this post: