With error 08 and I had a problem. I coped on my own, in the coffee machine services told tales, in each different.
1. the brewer can not be inserted, it could be taken out but it does not go in. The reason is a misaligned drive screw. Press and hold the small switch mentioned earlier and turn on the espresso machine. Wait until the espresso machine completes the test, that is, turn this screw. As it finishes ie it asks to rinse the system you can release the button, the brewer should be able to be mounted.
2. during startup, error 08 immediately appears and the coffee maker immediately shuts down. The reason is that the motor draws too much current, the brewer is seized. Remove the brewer, if you can not remove it, press the switch button several times ( 3 - 5 times ) until it passes the test (ready to work) , then remove the brewer and very carefully wash it and descale the system. Very important, it is necessary to lubricate the brewer with dedicated silicone grease. The cost is 15 - 20 zł, the manufacturer is arbitrary, the important thing is that it is dedicated to espresso machines.
In the service they will tell you to replace the motor, brewer, gaskets or something else. The cost is 300-400 zl plus parts. This is nonsense, a cash heist, do not be fooled.
In the brewer in the place that drives the screw, on both sides there are tiny recesses on the axis that rotates, there you should apply a small amount of grease, a small dot and leave it like that. This is the most important place. In general, you should lubricate the entire brewer every few months. There are videos on the web on how and where to lubricate. Only the brewer is lubricated.
close
Share this post: