Hello everyone!
On my Nivona CafeRomatica (NICR 626), all the liquid ends up in the drip tray every time I rinse and draw coffee. It worked fine until the brewing unit was removed for cleaning once a little "rough". I do not know, however, whether this is now the cause that this might have loosened something somewhere or how the described can be the consequence.
After researching the problem, I had concluded that either the drain valve or the brewing unit could be a defect, a seal not properly attached or something similar. Both, so first drain valve and then the brewing unit, but I have already replaced with new spare parts - unfortunately unsuccessfully, it still runs everything into the drip tray. It seems as if the water leaks out at about the transition from the drain valve to the inlet nozzle of the brewing unit.... I once captured this in 2 videos, one while rinsing, one while brewing coffee:
Flushing:
: https:
ür any tips on what else could be tested or what could be the cause, I would be very grateful.
best regards,
m0rten
close
Share this post: