Hello
,after I replaced the drain valve I can no longer get the brew group inserted. At the first start attempt is probably something went wrong. In any case, no coffee came and I got the brew group only with much fiddling from below out again.
Now it seems as if the motor pin is a little twisted in relation to the holder in the brew group. In any case, it does not go in. At the brew group is such an adjuster with which one should be able to adjust. That is not enough but not.
I have again checked all disconnected connectors and the limit switches and I have not noticed anything.
Does anyone have a tip?
Greetings Klaus
close
Share this post: