Good evening,
an intermediate result, which should actually be a final result....I have the machine 2x, both partially defective.
The drive of the machine around which it was first does not move, even with the switch pressed.
I then disassembled the second machine, cleaned, new seals, lubricate, etc.. It cost me 2 days and a few euros.
I just turned it on, unfortunately with several implausible errors:
1) Error messages drawer missing comes constantly
2) Error messages empty drawer (although empty)
3) Cleaning indicator constantly lit, if you release the cleaning comes a little water from the nozzles, but in addition there is some water in the bowl. Is this normal?
4) I can not descale because the cleaning light is always on.
It seems to me that quite little water comes out of the front nozzles, but I do not know the machine......
It has stood very long, I read somewhere flowmeter or pump could be full of air or faulty. But how can I check this? Multimeter?
Vg Stephan
close
Share this post: