Dear forum participants, I ask for your help in solving my problem.
After a half year break I have taken my old AEG CF350 in
operation again today. I was immediately "prompted" to decalcify the machine.
Decalcification takes place in 14 steps, the sequence of the individual steps took considerably longer than I had remembered. From step 7 the engine has properly overheated, at step 9 the steam pressure has been so high that the
steam nozzle has been pushed out of the holder with a loud bang.
Then it has calmed down again. Decalcification has been properly completed. I've shut down the machine.
The routine started to run normally when the device was put into operation again, only the message "device heats" would still light up if I hadn't switched off the device after 15 minutes...
What could have happened ? Where should I start the troubleshooting ?
To this end I would like to mention that I am ambitious, but have almost no idea of electrics/electronics !
Best regards from Austria
Roland
close
Share this post: